Motion Activated Battery-Powered Flexible LED Light Strip

Description

Here is a motion activated LED light strip module designed for lighting areas only when the IR sensor detects movement. The light automatically turns on and shuts off after 10-seconds with no movement. In applications where there are no outlets, this LED strip is perfect as it's powered by a 8AA battery-pack and can last for longer than 30-hours. The unit mounts easily with mounting holes and or double-sided tape.

Plenty of Uses

These kits can be used for accent lighting, power outages, dark closets, camping, drawers, under-cabinets and a much more (application photos below). Because the light strips easily contour around curves and are installed by peeling the stick backing, they can be used almost anywhere by anyone looking for quick and easy lighting.

Choose Your Density

This comes in the standard or high density LED flex strip. The standard-density strip has 30-LEDs/M and can be cut every 4-inches. The high-density strip has double the LEDs (60-LEDs/M) and is cuttable every 2-inches. See table to the right for LED, Lumen and run-time numbers:

Choose Your Color

These strips are offered in: Warm White, Neutral White, Cool White, Red, Green Blue and Yellow.

Cut to Size

If you have an area that is smaller than 20”, you can actually cut the strip. Just cut right along the black cut lines!

Battery Pack

The battery pack holds 8 AA batteries that will power the standard density strip for 30+ hours. When the batteries run out, just switch them out with new batteries and you are good to go. The strip turns on via a slider switch on the side of the pack. We have also put double sided tape on the back of the pack (just like the strips) so you can easily mount it. The motion sensory does draw a small amount of power, over time this will wear out your batteries even when the light is not in use that often. For this reason we recommend users use rechargeable batteries so you don't have to replace them every time.

Motion Sensor

The motion sensor has screw-in terminals to attach the power from the battery and the strip itself. Dimensions of the sensor are (L)89 X (W)59 X (H)45mm.

Installation - 4 easy steps

1. Fill battery holder with 8AA batteries
2. Peel adhesive backing off strips/battery pack
3. Mount wherever you need
4. Switch on!

LED Motion Light - Product Review

We published an article that breaks-down each component of this module in detail and outlines all the benefits and features. To learn more please check-out that post here: Automatic Lighting with Motion Sensor LED Light Strip Module

Applications

Full Documentation

LED Flex Strip Documentation