COB EZ Click-Tight LED Strip Connector

Description

EZ Clip connectors make extending led strips easy! This particular version is specifically for COB LED Strip lights. Don't want to solder? Than these LED strip light connectors are the next best thing.

The Best LED Strip light connector around!

These connectors are super simple to use! Whether you need to make an end-to-and connection or need to add a gap between strips with wires, this connector has you covered.

Strip-to-Strip: Easily connect a strip into either end for a gapless connection

Strip-to-Wire: Strip connector clips onto the end of the strip but on opposite end you can connect wires for going back to the power source or continuing to the next strip.

How to connect to LED Strips

On the strip side there will be 2 sharp teeth sticking straight up where you need to slide the strip in. Make sure to lift up the clear plastic tab and slide the strip in as far as you can, making sure it is on top of these teeth. Once it is in as far as possible, click the tab down. The teeth should pierce up through the bottom of the strip and through the copper pads, making for a solid connection.

How to connect to Wire

Clipping wires into the connector is as easy as sliding wires in the grooves at the bottom of the wire side connector. Make sure the wire is in as far as it can go and clip the clear plastic tab down.

NOTE: We recommend between 20-22AWG wire.  24AWG wire is too thin for the clips to make a solid connection. 22 AWG will work best with these EZ clips, but 20AWG will work, the tab will just need more force to clip tight.

Example Photos